Get Price

Cyanide Leaching Of Sulphide Gold

  1. Home
  2. Jaw-crusher
  3. Cyanide Leaching Of Sulphide Gold
  • The cyanide leaching of gold in solutions containing sulfide

    The Cyanide Leaching Of Gold In Solutions Containing Sulfide

    Since the sulfide minerals are to some extent soluble in cyanide solutions, there will always be some sulfur species present in the leach solution. It has been shown that soluble sulfide hinders the rate of gold leaching, forming a protective layer of the type Au/S x.

  • The effect of sulfide minerals on the leaching of gold in

    The Effect Of Sulfide Minerals On The Leaching Of Gold In

    Weichselbaum et al. (1989) found that the addition of trace amounts of sodium sulfide to the cyanide solution dramatically hindered gold leaching and ascribed it to the formation of a passive layer of Au 2 S on the gold surface.

  • Cyanide leaching of gold in solutions containing sulfide

    Cyanide Leaching Of Gold In Solutions Containing Sulfide

    The elemental sulfur has been identified as one of the main contributors to the formed passivated film both in the thiosulfate leaching of gold and the

  • Cyanide Leaching Chemistry Gold Cyanidation

    Cyanide Leaching Chemistry Gold Cyanidation

    Cyanide Leaching Chemistry. In a relatively simple system of this type the gold dissolves readily. The only requirements are that the gold be free and clean, that the cyanide solution contain no impurities that might inhibit the reaction, and that an adequate supply of oxygen be present in the solution throughout the reaction period.

  • Gold Metallurgy Leaching in Cyanicides

    Gold Metallurgy Leaching In Cyanicides

    How Thiocyanate Affect Gold Leaching. The reason for the lower cyanide consumption obtained with intense aeration is probably connected with the reactions which take place when alkaline sulphide decomposes in cyanide solution. Alkaline sulphide is one of the initial products of the reaction between pyrrhotite and alkaline cyanide solution.

  • Sulphide Gold Ore Treatment by Leaching and Flotation

    Sulphide Gold Ore Treatment By Leaching And Flotation

    Problem with gold recovery from sulphide ore How may a mill get the maximum recovery of gold from a sulphide ore, at the least capital cost and at the same time obtain the highest net return.This latter point is most important. In many cases a gold mill using an all-cyanide flowsheet with fine grinding of all the ore will report very low gold content in the tailings

  • Oxidative leaching of refractory sulphidic gold tailings

    Oxidative Leaching Of Refractory Sulphidic Gold Tailings

    Cyanide leaching on the same gold tailings in an optimized DRDGOLD process achieved on average 65% extraction of gold. In this investigation, the extracted gold with Bmim HSO 4 /thiourea/ferric ion was 42.6%, which was less than in the cyanide process . Thus, under the experimental conditions tested in this study, the acidic ionic liquid leaching was not better

  • Simultaneous sulfide oxidation and gold dissolution by

    Simultaneous Sulfide Oxidation And Gold Dissolution By

    In cyanide leaching, it has been suggested that lead nitrate reduces or prevents the formation of sulfide ions layers on gold by coating the sulfide minerals, reducing the dissolution of sulfide minerals (Deschnes, 2005). However, identical phenomena is not desirable nor suggested in direct chloride leaching, due to necessary sulfide oxidation to liberate gold from pyrite and/or

  • A fundamental study of the alkaline sulfide leaching of

    A Fundamental Study Of The Alkaline Sulfide Leaching Of

    system was studied as an alternative to cyanide for recovering gold from elemental sulfur. It was found that the dominant lixiviant for gold in this system is sulfide, and polysulfide was ascertained to be the oxidant. The leaching reaction was determined to be chemically controlled, thus highly dependent on temperature.


    Comparison Of Cyanide And Thiosulphate

    cyanide leaching in 2 hours. The relatively low specific energy consumption for microwaving indicates that this method has considerable potential. Feng and van Deventer (2010) studied oxidative pretreatment in thiosulphate leaching of sulphide gold ores. The sulphide minerals were partially decomposed in the pretreatment

  • Cyanide Process Gold Cyanidation Process Gold Leaching

    Cyanide Process Gold Cyanidation Process Gold Leaching

    If the ore containing the gold has other forms of metals or any kind of sulphide minerals then it requires additional kind of treatments before going through the process of leaching. The gold is mixed with the sodium cyanide which leads to the following Elseners equation and reaction. This is done to make soluble gold Now the gold is soluble.

  • Gold Extraction from Refractory Sulfide Gold Concentrates

    Gold Extraction From Refractory Sulfide Gold Concentrates

    Aug 25, 2021 The result is excess consumption of cyanide needed for leaching gold . Lower leaching efficiency of refractory ores can make the whole process uneconomic . Sulfide minerals must be removed by an oxidative pre-treatment process to efficiently leach the gold with cyanide, as in the case of pyrite bearing ore, Eq. 3 .

  • Gold Agitation Cyanidation Leaching

    Gold Agitation Cyanidation Leaching

    Oct 18, 2019 Cyanide is added to the grinding operation, and side immersion is performed to improve the leaching efficiency. For sulfide gold-bearing ores, flotation enrichment is often used. Or separating out some gold-bearing sulfide concentrates from flotation concentrates, such as gold-bearing copper concentrates, and finely grinding them to 90%-95% ...


    Gold Recovery Of Refractory Sulfide

    Cyanide leaching of the concentrate was performed at 20%-w/w of solid (500 gram of refractory sulfide gold ore concentrate) in a 2.5-liter glass reactor with aeration and stirred at 250 rpm. Leach solutions were prepared using deionized-distilled

  • Predicting Cyanide Consumption in Gold Leaching A

    Predicting Cyanide Consumption In Gold Leaching A

    Anderson, C.G. Alkaline sulfide gold leaching kinetics. Miner. Eng. 2016, 92, 248256. Google Scholar Muir, D. A review of the selective leaching of gold from oxidised copper-old ores with ammonia-cyanide and new insights for plant control and operation. Miner. Eng. 2011, 24, 576582. Google Scholar

  • A Review on Alternative Gold Recovery Reagents to Cyanide

    A Review On Alternative Gold Recovery Reagents To Cyanide

    Aug 18, 2016 Another big disadvantage of cyanide is the low leaching efficiency of refractory sulfide minerals or gold resources that contain copper or carbonaceous preg-robbing materials. Additionally, these resources afford a higher demand of


    Influence Of Preaeration On Cyanide Leaching

    improves gold leaching (galena). According to Weichselbaum et al. (1989), with the addition of trace amounts of sodium sulphide to the cyanide solution, gold leaching is prevented because of the formation of a passive layer of Au 2 S on the gold surface. Similar results were obtained

  • Guides For Highsulfide Gold Processing

    Guides For Highsulfide Gold Processing

    Mar 17, 2020 High sulfide gold ore refers to a certain gold ore with 20% -30% of gold wrapped by sulfide (mainly pyrite). Because most of the gold in high-sulfide gold ore exists in the form of sulfide-encapsulated gold, when using direct leaching process, the consumption of gold leaching agent and cost of gold leaching production will increase, and gold processing

  • P2 Gold Provides Update on Gabbs Project

    P2 Gold Provides Update On Gabbs Project

    Oct 19, 2021 In all cases, the sulphide ores were treated by conventional milling followed by flotation producing a gold/copper concentrate and cyanide leaching of


    Influence Of Lead Nitrate On Cyanide Leaching

    increase in gold and silver recoveries between 0.4-1.2% for gold and 3.9-11.6% for silver at the end of 24 hours leaching by the addition of lead nitrate as 0.1-0.5 kg/Mg. NaCN consumption decreased or did not change except for the Ovacik ore. In the case of the Ovacik ore it slightly increased. Keywords lead nitrate, gold, silver, cyanide ...

  • What is Gold Cyanidation with picture Info Bloom

    What Is Gold Cyanidation With Picture Info Bloom

    Gold cyanidation extracts gold from the ground. Gold cyanidation, also called cyanide leaching, is a process used to extract gold from raw ore taken from the ground. It uses cyanide to dissolve the gold within the rock, which, itself, is not soluble in cyanide. The gold is then drawn out in a liquid form that can be treated to remove the cyanide.

  • US5250272A Process for leaching precious metals with

    Us5250272a Process For Leaching Precious Metals With

    A process for leaching gold and silver from ores and ore concentrates is disclosed using a cyanide leaching solution and hydrogen peroxide and maintaining an oxygen concentration of 2 to 20 Mg of O 2 /liter. In the invention, leaching takes place in the presence of decomposition catalysts and preferably the formed cyano-complexes are separated during leaching from the

  • Fundamentals and applications of alkaline sulfide leaching

    Fundamentals And Applications Of Alkaline Sulfide Leaching

    Thus, as seen, there are significant economic incentives with the use of alkaline sulfide leaching of gold instead of cyanide. This advantage was illustrated before in the treatment of gold bearing chalcopyrite where conventional pressure leaching followed by cyanidation is far more expensive. Table XXII - Comparative Cost of Gold Leaching ...

  • The influence of preaeration on cyanide leaching of a non

    The Influence Of Preaeration On Cyanide Leaching Of A Non

    The leaching behaviour of a sulphide gold-silver ore was investigated in terms of a relationship between gold and silver extractions and cyanide consumption. Ninity five Au % and 88.0% Ag extractions were obtained under the determined conditions of 24 h leaching duration, -74 m particle size, 40% solids ratio, 4 g/dm3 NaCN concentration, and ...

  • Recovery of Gold in Pyritic Sulfide Ores Mine

    Recovery Of Gold In Pyritic Sulfide Ores Mine

    Using cyanide to recover gold from sulfide ores generally results in 30 to 35% recovery, and the best I have heard of is around 50% recovery. The fine coating of a iron compound definitely appears to be a key component of the inability of cyanide to


    Investigation Of The Amenability Of A Copper

    In this study, the amenability of a copper-rich gold ore (108 g/t Au, 1.60% Cu) to cyanide leaching was investigated. Direct cyanide leaching of the ore showed that the gold extraction was very low by 18.4% over 24 h., indicating that the ore is highly refractory. Sulphuric acid pretreatment for the removal of acid-soluble copper was found to ...

  • Gold Recovery by Cyanide Leaching A Case Study of

    Gold Recovery By Cyanide Leaching A Case Study Of

    Justin William Ntalikwa. Gold Recovery by Cyanide Leaching A Case Study of Small Scale Miners in Tanzania. American Journal of Engineering, Technology and Society. Vol. 2, No. 6, 2015, pp. 162-166. Abstract In this study, sodium cyanide leaching technology has been used to recover gold from tailings that are used by Mawelo small

  • Gold Bull Confirms Excellent Gold Metallurgical Recoveries

    Gold Bull Confirms Excellent Gold Metallurgical Recoveries

    Oct 14, 2021 Figure 1 Map showing location of the mineral resources at Sandman. Table 1 Abel Knoll preliminary test work results from cyanide bottle roll leach test work with gold extracted in

  • Technology Antilles Gold

    Technology Antilles Gold

    The patented Albion Oxidation Process is a processing technology that permits the extraction of precious metals from refractory ore by the conventional cyanideinleach (CIL) process. Most sulphide ores can not be leached at acceptable rates at atmospheric pressure. Feed to the Albion Process is in the form of a sulphide concentrate ...


    Infield Testing And Validation Of Thiosulphate

    for an innovative, new leaching process (a non-toxic leach reagent) - Elimination of cyanide use in the gold recovery and production process - Smelting and forming gold into bars - Additionally, this leach process design also intended to demonstrate how a small mobile plant could operate in the field, to unlock small/high grade stranded ...


    Thiosulphate Leaching An Alternative To

    similar gold recovery as cyanide in some cases, while in cases such as preg-robbing ores (naturally occurring carbonaceous material that preferentially absorbs the gold cyanide complex but not the gold thiosulphate complex), it can yield substantially better recovery than cyanide. The thiosulphate leaching of gold

  • Cyanide leaching of gold in solutions containing sulfide

    Cyanide Leaching Of Gold In Solutions Containing Sulfide

    The treatment of a copper sulphide-bearing gold ore by direct cyanide leaching, ammonia pretreatment and ammoniacal cyanide leaching was investigated. Dissolution behaviour of gold and copper in ...

  • The Metallurgy of Cyanide Gold Leaching An Introduction

    The Metallurgy Of Cyanide Gold Leaching An Introduction

    Oct 20, 2014 Leaching gold with a cyanide solution remains the most widely used hydrometallurgical process for the extraction of gold from ores and concentrates. Despite the difficulties and hazards of working with cyanide, no other process has yet been proven to be an economic viable alternative. ... Sulphide Minerals Some sulphide minerals (e.g ...

  • PDF Reactions of gold and sulfide minerals in cyanide media

    Pdf Reactions Of Gold And Sulfide Minerals In Cyanide Media

    During the cyanide leaching of sulfidic gold ores, the sulfide minerals dissolve into the leach solution and produce metastable sulfur species, such as sulfide, bisulfide, polysulfide, elemental ...

  • Simultaneous sulfide oxidation and gold dissolution by

    Simultaneous Sulfide Oxidation And Gold Dissolution By

    Aug 15, 2021 The investigation shows that the presented cyanide-free leaching approach can address the refractory nature of gold concentrates in atmospheric pressure - the simultaneous oxidation of sulfide minerals and gold in a single unit process providing new horizons for the future of the utilization of refractory gold ores.